SECTION 1 – CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Active VPR 2-10-10
Active AgriScience Inc.
3422 Millar Ave
March 31st, 2020
Active AgriScience Inc.
For professional use only. Use only as labeled
SECTION 2 – HAZARDS IDENTIFICATION
|Based on the available information, this material is not considered hazardous by HPR (WHMIS 2015) or the OSHA Hazard Communication Standard (29 CFR 1910.1200).|
SECTION 3 – COMPOSITION / INFORMATION ON INGREDIENTS
Contains no hazardous ingredients ≥ to 0.1%.
SECTION 4 – FIRST AID MEASURES
Immediately flush eyes with a large gentle stream of water for 15 minutes while holding the upper and lower eyelids open. Seek medical attention if irritation persists.
Flush skin with plenty of water for 15 minutes. Remove contaminated clothing and wash before reuse. Seek medical attention if irritation persists.
Move victim to fresh air. Allow the victim to rest in a well-ventilated area. If breathing is difficult, give oxygen. If not breathing, give artificial respiration Seek medical attention if irritation persists.
Rinse mouth. Never give anything by mouth to an unconscious person. DO NOT induce vomiting without physician’s direction. If vomiting occurs naturally, have victim lean forward with head down to avoid breathing in vomit, rinse mouth. Seek medical attention if you feel unwell.
Most Important Symptoms, both acute & delayed.
|No known side effects. Treat symptomatically.|
SECTION 5 – FIRE FIGHTING MEASURES
Product will not burn or support combustion.
MEANS OF EXTINCTION
Use extinguishing methods appropriate for the surrounding fire.
FLASHPOINT & METHOD
AUTO IGNITION TEMPERATURE
UPPER FLAMMABLE LIMIT
SENSITIVITY TO IMPACT
LOWER FLAMMABILITY LIMIT
SENSITIVITY TO STATIC DISCHARGE
HAZARDOUS COMBUSTION PRODUCTS
Toxic and irritating gases may be released when product is heated to decomposition.
SECTION 6 – ACCIDENTAL RELEASE MEASURES
LEAK & SPILL PROCEDURES
|Wear personal protective equipment outlined in SECTION 8. Contain spill then adsorb with inert material and place into suitable clean containers for later disposal. Do not release into drains or the environment.|
SECTION 7 – HANDLING AND STORAGE
|Do not handle until all safety precautions have been read and understood. Do not get in eyes, or skin. Do not breathe mist/spray. Wear chemical resistant gloves, and eye protection – See SECTION 8|
Wash hands before eating, drinking, smoking and when leaving work.
Store in a cool, dry, well ventilated area away from food or feed storage. Keep out of reach of children. DO NOT FREEZE.
SECTION 8 – EXPOSURE CONTROL / PERSONAL PROTECTION
Local or general ventilation should be sufficient.
PERSONAL PROTECTIVE EQUIPMENT
Use waterproof gloves when handling or applying this product.
The use of eye protection is recommended when handling.
Use an approved air purifying respirator if mists are present and ventilation is absent or poor.
SECTION 9 – PHYSICAL AND CHEMICAL PROPERTIES
7.0 – 7.5
SOLUBILITY IN WATER
SECTION 10 – STABILITY AND REACTIVITY
Stable under normal conditions of use and storage.
INCOMPATABILITY WITH OTHER SUBSTANCES
HAZARDOUS DECOMPOSITION PRODUCTS
SECTION 11 – TOXICOLOGICAL INFORMATION
Does not meet criteria.
Does not meet criteria.
EYE / SKIN IRRITATION
Not expected to be an irritant.
Ingredients are not sensitizers.
No component of this product present at levels ≥ 0.1% is identified as a probable, possible, or confirmed human carcinogen by IARC, or ACGIH.
SECTION 12 – ECOLOGICAL INFORMATION
SECTION 13 – DISPOSAL CONSIDERATIONS
Dispose of this product and its container in accordance with Federal, State, Provincial and Local regulations.
SECTION 14 – TRANSPORT INFORMATION
TDG: Not regulated for transport.
DOT: Not regulated for transport.
SECTION 15 – REGULATORY INFORMATION
|This SDS is prepared to comply with the Global Harmonized System of Chemical Classification and Labeling (GHS) and conforms to the requirements of HPR (WHMIS 2015) & OSHA Hazard Communication Standard (29 CFR 1910.1200).|
SECTION 16 – OTHER INFORMATION
To the best of our knowledge, the information contained herein is current and correct as of the date of this SDS, however, the information and recommendations are presented without warranty, representation or license of any kind, with respect to their accuracy, or completeness, and the seller, supplier and manufacturer (Supplier) of this material or their affiliates, disclaim all liability for reliance on such information and recommendations.
Final determination of the suitability of any material is the sole responsibility of the buyer or the user (recipient). All materials may present unknown hazards and should be used with caution. The recipient assumes all risk in connection with the use of this material and assumes all responsibility for ensuring the material is used in a safe manner in compliance with applicable environmental, health and safety laws.
The supplier does not warrant the merchantability of this material or the fitness of the material for any particular use and assumes no responsibility for injury or damage caused directly or indirectly by the use of this material.